Fibaro Flood Sensor FGFS-101
Description:
The sensor housing flooding Flood Sensor FIBARO reminds perfect drop of water. Made of high quality white glossy plastic. The device is completely maintenance-free and requires no special installation. By using telescopic probe coated with 24-carat gold, to adapt to the shape of the surface, the only one on the market is working properly on uneven surfaces. - The module can be installed in even the most difficult accessible location, such as building a bathtub, washing machine or dishwasher. Able to work in any position, even if it does not fit in the critical place of possible malfunctions, it can connect to a wired probe and bring the sensor where it is needed - says Maciej Fiedler, Director. FIBAR Development Group. What is important, depending on the point at which it is to work, it can be powered by batteries, as well as from the power supply. Will work successfully with both the voltage 12 and 24 Volt. The sensor is designed to work in the toughest conditions. Properly operating at low (-20 ° C) and high (95 ° C) temperature. Its housing provides temporary waterproof, allowing for direct contact with the liquid and the displacement prevent drowning and cessation of communication. Flood Sensor Housing FIBARO was secured before opening the device off and destruction. Special tamper sensor responds to a 30 degree tilt and shake the device. Built-in siren will respond quickly in the event of flooding, rapid changes in temperature or sabotage. The device, in addition to the siren, he can inform about the event colorful lighting with built-in RGB LEDs. Flood Sensor FIBARO functionality goes far beyond the detection of flooding. With the additional connector to the signal, we can integrate the device with almost any home alarm system. The sensor responds to any sudden changes in temperature, therefore an excellent support system for your home fire. Using this function, you can prevent a fire in its initial stage and harmless when detecting threats may have a problem with fire detectors. The module will also help in managing the floor temperature, and integrated with heated mats will prevent icing the driveway in front of the garage. The greatest potential for the device reaches the integration of building intelligence system. Handling complex scenes can control the Home Center 2 itself take the appropriate steps immediately after detecting the risk of flooding and fire. Disclosure of liquid water damage sensor 2 in the vicinity of the machine to cut off the water through the Relay Switch connected to the water solenoid valve, and Wall Plug, to which was attached a washing machine, turn off it, that has not been damaged. PRESS RELEASE In case of fire detection, disconnect Switch Relay solenoid valve and the control panel lights will take care of the demarcation of the escape route and get rid of smoke by running ventilation work at the maximum level. By integrating sensors and a smart owner will receive information about the threat to the mobile phone or tablet.
Technical data:
• Supply voltage: 12 - 24 VDC • Battery :: CR123A • Maximum voltage at the terminals of output: 40V (AC or DC) • Compliance with EU EMC Directive 2004/108 / EC; R & TTE Directive 199/5 / EC • Radio protocol: Z - Wave • Radio frequency: 868.4 MHz EU; 908.4 MHz US; ANZ 921.4 MHz; RU 869.2 MHz; • Range: up to 50 m in the open; up to 30 m in buildings (depending on building materials, layout and design of the building and the landscape) • Operating Temperature: 0 - 40 ° C * • Temperature sensor range: -20 to 100 ° C • Temperature Sensor Measuring accuracy: 0,5 ° C ( for a range of 0-40o C) • Dimensions (diameter x height): 72 x 28 mm * With the constant power limit temperature is -20 ° C to 70 ° C
Additional Information:
- Unique, hard submersible design,
- Detects flooding or fire,
- Battery powered or DC,
- Communicates with the Z-Wave network or wired alarm system
- Enables wireless software upgrade.
You might also like
8 other products in the same category: